Replacement Engine Wiring Loom needed!

[Shaun Lee]

Guys, I have a 206cc 1.6 16v NFU 2002 plate. I need a replacement engine wiring loom. Can I use any other model's loom or do I have to use the specific one. If so, where can I get the part number? I think, according to Service Box that I have a RHD without multiplexing and with A/C and the part number might be 9642519080.

But on the loom I have found the number 9640385180

Can anyone help?

Thanks

[Enright]

You can't just use another engine loom from any other model (or even any other 206 CC) because they went through numerous under-bonnet small revisions and you need the matching main loom, ECU and BSI for each.

Service Box is good for telling you what the exact part number that you need should be when you put your VIN number in.
But if you leave out the VIN number an just do a search by model, then it will give you the alternative part numbers for each model revision.
You're likely to be OK if you get one from the same model and year, but to be sure you would be best to check the donor's VIN number too.
Hope that helps a bit.

[Shaun Lee]

Ok, so I got a replacement loom. But I can't fit two connectors any where.

Fuse box Delphi BSM B3
No1. Thick brown cable with hole for bolt from two pin plug from fuse box labeled BATT
No2. Three pin plug. Grey & white to Pin 2 on Black multiway plug PM1 on fuse box, Earth and Grey & Red to pin 14 on same Black Multiway.

a, What does it do?
b, Where does it go?

*URGENT*

[Shaun Lee]

Update: Thick brown wire connects to starter motor. Just got to find other one.....

[greengecko]

hi im also going throught a tough time with loom issues
just had a conversion done from a 1.4 to a 1.6 from a cc to a hatch.
the wiring from cc has been messed up bad was wondering if any1 knows or has any for sale with ecu bsi,locks and fuse box the complete wiring package for the 1.6cc im installing the digital cc climate control a/c unit so it would be perfect if i could get a cc donner wiring

thanx in advance

[Shaun Lee]

Worked out where the cable went. Tried BSI reset three times. No joy. Any pp2000 users near peterborough, ely or huntingdon still active ? Or anyone with a cable that works. I have pp but no cable. The missus has just told me to scrap the car for £50 and give up my new job that I started 4 weeks ago. Its costing me £60 a week to have this car standing. I need serious help on this one.

[Capncol]

hi im also going throught a tough time with loom issues
just had a conversion done from a 1.4 to a 1.6 from a cc to a hatch.
the wiring from cc has been messed up bad was wondering if any1 knows or has any for sale with ecu bsi,locks and fuse box the complete wiring package for the 1.6cc im installing the digital cc climate control a/c unit so it would be perfect if i could get a cc donner wiring

thanx in advance

Read Enrights post above yours. You need the right loom. A 206CC BSI wont work in a hatch.

[greengecko]

can you guide me through the right path i have the engine installed and no wiring
do you have any clue as were i can get the correct one that would work with the engine?
i would be a great help