206cc blower

Sbm251 · Post by **Sbm251** » Wed Sep 02, 2015 1:44 pm

Hi I'm new just signed up as I can not find the answer.
Removed my blower from my 206cc it works I have tested it but I'm not getting a reading from the wires that link to the blowet inside the car. What could be causing this can anyone help me please.

Post by **Capncol** » Wed Sep 02, 2015 7:30 pm

Details of the car would be good!

Sbm251 · Post by **Sbm251** » Wed Sep 02, 2015 7:44 pm

2003 206cc manual 2 ltr

With the auto aircon dash it all works but will not blow the blower

Thanks col and sorry

leegsi · Post by **leegsi** » Wed Sep 02, 2015 9:27 pm

Its normally the heater resistor that gives up.

Look like this: http://www.ebay.co.uk/itm/CITROEN-XSARA ... 2338a4d701

Post by **Capncol** » Thu Sep 03, 2015 6:08 pm

Leegsi is probably right, but check the fuse hasn't blown, then check the connecting plug hasn't melted.

Sbm251 · Post by **Sbm251** » Thu Sep 03, 2015 7:15 pm

Thanks so much for the help.

I can't locate the resistor can not see it near the clutch pedal side.
The car is auto ac is the resistor in the fan has a metal spike thing hedgehog if that makes sense I'm guessing the resistor is in the fan ?

Or am I not looking hard enough for it the clutch pedal side

Sbm251 · Post by **Sbm251** » Thu Sep 03, 2015 7:16 pm

ive just clicked the link thanks so much I'll buy that thankyou

Just connected the blower to the battery it works could this still be the resistor or have I got bigger problems

tenpole · Post by **tenpole** » Sun Sep 06, 2015 9:31 am

It will be the resistor. If you have the fan out reach under the shaft where the fan sits and find the resistor at the top. To get to the connector you need to remove the centre display. The trim just slides back and up toward the windscreen. Remove the lcd and behind that at the back is where the wires goto the resistor.

ribs99 · Post by **ribs99** » Fri Sep 18, 2015 9:58 am

If these are the same as the climate control on the 306 then they don't have a resistor pack. They have an electronic speed controller instead which is mounted on the side of the fan assembly.

neil0804 · Post by **neil0804** » Sat Nov 07, 2015 1:34 pm

Would it be the resistor if the blower motor only runs slowly even when climate is asking for full speed?

tenpole · Post by **tenpole** » Sat Nov 07, 2015 5:49 pm

I don't know if it has the same resistor in the climate control system. Usually with the normal system it is only top speed you can get by bypassing the resistor. Like I have with mine.

Slo · Post by **Slo** » Sat Nov 07, 2015 7:00 pm

The resistor controls the variable speed so if its only runs slow then yes its probably toast.

I have climate control and ac in mine and it didnt work when i got it cos the resistor was goosed.

tenpole · Post by **tenpole** » Sat Nov 07, 2015 11:02 pm

running slow means current is passing through resistor.

Slo · Post by **Slo** » Sun Nov 08, 2015 12:19 am

yes but if its fixed at a slow speed its bolloxed

tenpole · Post by **tenpole** » Sun Nov 08, 2015 12:41 am

No. I think it might be the plug that goes into the resistor melted. Assuming it even has a resistor pack being climate control, someone has stated they do not have one.

206cc blower

206cc blower

Re: 206cc blower

Re: 206cc blower

Re: 206cc blower

Re: 206cc blower

Re: 206cc blower

Re: 206cc blower

Re: 206cc blower

Re: 206cc blower

Re: 206cc blower

Re: 206cc blower

Re: 206cc blower

Re: 206cc blower

Re: 206cc blower

Re: 206cc blower