Fiiting chrome hoops

bel · Post by **bel** » Fri Jul 30, 2004 4:26 pm

Has anyone managed to fit these themselves??
Is it a easy or tricky task??
Bel

RickJAndrsn · Post by **RickJAndrsn** » Fri Jul 30, 2004 4:50 pm

Pretty easy once you have pulled the rear seats forward... (You have to pull them up then forward, IIRC).

Can have them done in 20 mins.....

Rick

bel · Post by **bel** » Fri Jul 30, 2004 4:56 pm

Thanks i pick them up tomorrow so ill have fun trying to fit them.

Post by **Lyndon** » Fri Jul 30, 2004 6:06 pm

ya it's dead easy, the new hoops may need slight adjustments to get the prongs to line up correctly tho but aren't a major hassle,just make sure ya roof's off

phonic · Post by **phonic** » Fri Jul 30, 2004 8:35 pm

see above, super easy, just pull rear seat backs hard towards you and they unclip and you will see where the 2 bolts for each hoop are.

bel · Post by **bel** » Mon Aug 02, 2004 10:35 am

Peugeot shut on me so should get them this saturday!
thanks for the replys!!

Chas · Post by **Chas** » Sat Dec 25, 2004 1:37 am

see above, super easy, just pull rear seat backs hard towards you and they unclip and you will see where the 2 bolts for each hoop are.

Just got a set of hoops for mine, do you have to loosen the nuts at the bottom of the back rest pads before you pull them up and towards you??

GhostRider · Post by **GhostRider** » Sun Dec 26, 2004 9:31 am

: Is the seat easy to put back afterward ?

: Or is it possible you brake some plastic pins and it will not hold ?

Greetzz

marcelnl · Post by **marcelnl** » Sun Dec 26, 2004 9:59 am

: Is the seat easy to put back afterward ?
: Or is it possible you brake some plastic pins and it will not hold ?

Greetzz

Nope, the seat backs are fixed with steel hooks and loops and they can come off without undoing the bolt........
On one of the back rests in my car the nut that is supposed to be fixed to the bodywork has come off (but was not do with fitting the hoops)

unscrew the bolts on the bottom of the rear seat butt rest, the undo the two screws holding the seat back rest and you'll be done in a jiffy and you'll not have to woory about them.