Multiplexing and head units

keilandy · Post by **keilandy** » Tue Sep 02, 2003 8:28 pm

Okay, after reading round a bit, I think I have figured out that I have a multiplexing motor because of a delay when changing from hi beam, having split hazard/lock buttons blah blah blah! Even though I have no idea what this ACTUALLY means even after searching for it on the forum (any explanation appreciated

).

I believe that this means I can get a connector for stalk controls/display unit to practically any make/model of head unit. Do I have this right? If so, any ideas here I can source one?

Cheers
Andy.

Alex LS · Post by **Alex LS** » Tue Sep 02, 2003 8:35 pm

No. It means you *cannot* get an adapter for virtually any make/model.

So far, it seems you're ok with Pioneer & Sony and I'm trying to confirm Kenwood although it seems Kenwood may be out of the question if the car was made between Nov01 and Sept02 because they use a different multiplex bus now and Autoleads are unwilling to develop an adapter for such a limited run.

keilandy · Post by **keilandy** » Wed Sep 03, 2003 2:51 pm

Do you know where you can get these connectors from for a Pioneer DEH P8500MP head unit? Looked on the Autoleads website but can only find connectors to ISO???

:

axl77 · Post by **axl77** » Wed Sep 03, 2003 11:12 pm

ask at this website http://www.connects2.co.uk/ perhaps they make something for the pioneer

keilandy · Post by **keilandy** » Tue Nov 04, 2003 2:03 pm

Can't find this on the website and when you try to send them an email it don't work. There's something wrong with the form on the website. :rolleyes:

Huu · Post by **Huu** » Wed Nov 05, 2003 7:04 am

no , email form dont work... use the email address at the bottom of the page sales@connects2.co.uk
i contact them several times and their respond were quite quick and helpfull

Pauline · Post by **Pauline** » Thu Nov 13, 2003 8:09 pm

Have you tried contacting Pioneer via their website? I found them v helpful